SIMPLE TO INSTALL No tools are needed, No cutting of the fuel line required. Install Turbomag close to the fuel injector/carburetor as possible by following the picture instruction below.

Installing Turbomag

1. Locate the fuel supply line under pressure feeding the engine from the fuel tank. Vehicles with fuel injection engines normally have two lines running parallel between the fuel tank and the engine, a supply line and a return line. While the engine is running, feel the lines and the colder one of the two will be the supply line.

2. Insert the nylon tie through the grooves that have the tie retainer slot. This is to help hold the tie in position while applying the Turbomag to the fuel line.

3. Simply place the Turbomag over the fuel supply line, at the accessible location as close to the carburetor or fuel injection system as possible. However do not install the Turbomag in close proximity to the alternator or any electromagnetic energy source. Installation on a metal line has given the best performance. In some cases there has been somewhat less effectiveness on plastic and rubber. We believe better radiation can be achieved through the metal; while we have had good positive results on all materials, if you can, choose a metal fuel line even if it is a connector before the carburetor etc. Do not install the device on braided metal fuel line. This should be replaced for base metal, rubber or plastic fuel pipe.

4. Align the Turbomag halves so as the side grooves are alike. Complete installation by wrapping the tie completely around the Turbomag making sure the tie fits into the side grooves. Trim off the excess tie. Check again whether the halves are vertically as well as horizontally alike.

Due to the cleaning and removal process of the carbon/varnish deposits inside the cylinders, the fuel consumption may temporarily increase during the initial cleaning cycle. Mileage will stabilize after a short time. Noticeable improvement may take up to four tanks of fuel and, for optimum results to be achieved, please allow 1,000 miles or 3 full tanks of gas. A clean air filter, or a measure of carburetor or injector cleaner mixed in the fuel will also help to give faster results and regular servicing is obviously still necessary. Increased performance and smoother running will often also be noticed.

Tornado Fuel Saver works on ALL Cars

Benifits from using Turbomag X-T
1. Up to 30% Increase in Engine Life
2. Up to 50% Reduction in Carbon monoxide and Hydrocarbon
3. Up to 10% to 22% Fuel Savings
4. Does NOT void vehicle warranty
5. Works on all vehicle including diesel
6. Save Up to $500 to $1,500 a Year and more

7. No cutting of the fuel line
8. Up to 10 Horse Power Increase
9. 0% Maintenance for Life
10. Less Than 5 Minute to Install